Ceremony

The ceremony will take place at Code's Mill, in Perth.  You can check it out here:  www.codesmill.ca (map and directions are down below).  It will begin at 5 o'clock in the afternoon and will be quick and beautiful.  As soon as all our hopes and dreams are realized we will move on to the reception, in which we eat and drink till we burst, then dance the night away.

Reception

The reception is in the same venue as the ceremony (hello, convenience), although you WILL have to walk about 10 feet to get to it, so make sure you're wearing proper footwear.... 

Immediately after the ceremony there will be a cocktail hour with appetizers and drinks, followed by a sit-down dinner, served to you by the lovely Code's Mill staff. 

With the exception of the cocktail hour there will be CASH BAR service, so please come prepared.

BRUNCH!!!!!

The day after the wedding we will be embarking on a brunch odyssey at a local eatery.  They have graciously extended their restaurant for our usage in exchange for a bit of paper...go figure.  The deliciousness will commence at 10:00 the Sunday morning and since we will be there, as our first post-wedding-married-forever act, you should be too.  We will be providing info, directions and eating tips at the wedding. Just bring your appetite and your hangover.  If you have any fork-related problems, please direct your questions to Nat Van Dine...

Map to Ceremony/Reception

map codes mill

Directions to Ceremony/Reception

Coming from Toronto
Take HWY 401 East. When you get to Belleville, take exit #544/HWY 37 toward Belleville/Tweed. Turn right, on Cannifton Rd.(HWY 37), follow HWY 37 through Tweed. Turn right, onto HWY 7. Once in Perth, turn right (2nd intersection) onto Wilson St. Continue on Wilson St. past Foster St.  You will see Code’s Mill on your left hand side. (Total driving time is approximately 4 hours).


Coming from Ottawa
Take HWY 417 West. Take exit #145/HWY 7, toward Carleton Place/Toronto. Continue on HWY 7, through Carleton Place. Once in Perth, turn left (2nd intersection) onto Wilson St. Continue on Wilson St. past Foster St.You will see Code’s Mill on your left hand side. (Total driving time is approximately 50 minutes).


Coming from Kingston
Take Perth Rd./CR-10 (from HWY 401-exit#617, from downtown Kingston-Division St.) toward Westport. Turn left onto Concession St./CR-42, turn right, onto Rideau St./CR-10 going through Westport. Continue on CR-10 until you get to Perth. Turn left onto Rogers Rd. At the “T”, turn right onto Peter St. At Wilson St. turn right again.  You will see Code's Mill on the left hand side. (Total driving time is approximately 1 hour).